INCH-POUND
MIL-DTL-18295F
30 January 1998
SUPERSEDING
MIL-C-18295E
14 April 1992
DETAIL SPECIFICATION
CHAINS AND FITTINGS FOR FLEET MOORING
This specification is approved for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification establishes the requirements for the manufacture, physical
performance, and acceptance of mooring chain assemblies. Mooring chain assemblies are to be
subjected to long term submergence in seawater and may be subjected to open storage in a marine
environment.
1.2 Classification. Fleet mooring chain assemblies, unless otherwise specified, are classified and
identified as follows:
Mooring Chain Assembly:
Group I
-
Chain
Type 1 - Chain link with studs modified to accept cathodic protection.
Type 2 - Chain link with studs not modified to accept cathodic protection.
Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data
which may improve this document should be sent to: Commanding Officer (Code 15E2), Naval
Construction Battalion Center, 1000 23rd Avenue, Port Hueneme, CA 93043-4301, by using the
Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter.
AMSC N/A
FSC 4010
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business